language
English
ChineseThe function of air compressor oil is to form a protective film between the critical points of the two friction screws to avoid contact between the screws, thereby buffering the friction effect, playing a lubricating effect, and reducing wear; in addition, there are cooling, noise reduction, Sealing, anti-rust and other functions.
Failure appearance: Lubricant failure. Troubleshooting: Indeed, whether it is a new air compressor that needs to be replaced after 500 hours of operation or every 4000 hours in the future, this is obtained under a standard environment, and in the screw type In the actual use of the air compressor, many factors will affect the performance of the lubricant. Because of this, we need to determine the replacement cycle according to the specific use environment.
So what factors will affect the replacement cycle of screw air compressor lubricants?
At present, the main points that everyone agrees on are:
1. The quality of lubricating oil: The quality of lubricating oil will directly determine the period of its use. As long as the lubricating oil produced by the manufacturer and qualified by the quality verification can be replaced once in 4000 hours in a standard environment, the replacement cycle of inferior lubricating oil is short;
2. Humidity of the air: If the humidity in the air is greater, it means that the more water enters the air compressor, and the mixing of water and lubricating oil will cause the lubricating oil to deteriorate, which will affect its service life;
3. Impurities: Including the impurities that enter with the air and the impurities generated by the air compressor due to friction, etc. Impurities will contaminate the lubricating oil and cause its failure;
4. Acid and alkaline gases: There are a lot of acid and alkaline gases in the use environment of some air compressors, and their types of gases will also affect the working performance of the lubricating oil, resulting in a shortening of its service life.
belt.
The belt has good elasticity, can alleviate impact and vibration during work, and move smoothly without noise. When the load is too large, the belt will slip on the wheels, which can prevent damage to other parts and play a safety protection role.
The belt has good elasticity, can alleviate impact and vibration during work, and move smoothly without noise. When the load is too large, the belt will slip on the wheels, which can prevent damage to other parts and play a safety protection role.
Failure appearance: poor belt elasticity. Troubleshooting: After the air compressor is turned off, the temperature in the standby body is cooled and there is no pressure, check the current status of the transmission belt. Because of the nature of the screw air compressor structure, how to replace and adjust it depends on its tightness. If there are no serious problems such as deformation, you only need to install the bolts accordingly, and then bring them to the required conditions. However, when it is damaged beyond repair, it must be replaced with a new one.
One of the precautions is that the tension of the belt must be consistent throughout and be prepared to prevent slipping. After installation, test run for about 30 hours and observe the changes. In fact, the key here is strength, mastering this degree can avoid accidents such as disconnection.
If the replacement and adjustment of the drive belt of the screw air compressor can be done well, it will also benefit the work of the motor and other accessories, which will reduce the load invisibly. After completing all the steps, fix the nose. It must be carried out in an orderly manner. The implementation must be rigorous and no mistakes can occur. In many cases, damages are caused by operating errors. Maintain sufficient vigilance, make adequate preparations, and make adjustments to the data in a timely manner.
Tel:86-574-62678766
E-mail:bzheng22@163.com
